Quickly locate your forgotten pinpointer with the handy lost-alarm.Ī lanyard and a tough, semi-rigid holster that attaches to any belt will keep your PRO-FIND at the readyįinding Targets The PRO-FIND 35 pinpointer allows you to accurately locate buried targets in holes, where a metal detector coil doesn’t fit. The PRO-FIND’s bright yellow handgrip is clearly visible for easy location, so you won’t leave it behind after you dig. Easily adjustable with separate +/– buttons The perfect companion for a waterproof detector.Īudio tones and vibration intensify as the probe approaches the target making target recovery easier, especially underwater!įive sensitivity levels allow you to precisely adjust for maximum depth and minimum noise in all ground conditions. Rugged waterproof design ideal for beach and river pinpointing. Great to use with non-discriminating detectors. Two different responses help you to identify ferrous junk from nonferrous treasure. The PRO-FIND 35 uses VLF transmission and incorporate Minelab’s unique Detector Interference Free (DIF) technology. Always check that the battery cap O-ring and screw threads are clear of dust, sand, and grit.The PRO-FIND 35 provides premium level functionality in a fully waterproof design for the serious detectorist. To maintain a waterproof/splash proof seal, ensure that the battery cap O-ring is periodically lubricated with silicone grease. One long beep followed by two short beeps will indicate when Factory Reset is complete. After two long beeps, continue to hold for 5 seconds. If + or – are not pressed at all when turning on the pinpointer, it will default to the last-use audio mode.įrom off, press and hold the Power button (5). To turn audio tones OFF, hold down – when turning on the pinpointer. To turn audio tones ON (default), hold down + when turning on the pinpointer. To disable Ferrous Tone ID, press and hold – for 3 seconds, until the unit emits one long beep. Ferrous Tone ID is effective when the probe is 10–15 mm (approx. When the pinpointer is close to the target: Interrupted chirping tones upon detection indicate a ferrous target. To enable Ferrous Tone ID, hold the pinpointer away from metal objects, then press and hold + (6) for 3 seconds. When minimum sensitivity is exceeded (level 1), there will be a long beep. When maximum sensitivity is exceeded (level 5), there will be a long beep. When the battery level is critically low, the pinpointer will automatically power off. Low Battery is indicated by a flashing LED. If the pinpointer is inactive for another 5 minutes, it will automatically power off. This will repeat every 10 seconds unless a detection occurs. When the pinpointer is switched on but has been inactive for approximately 3 minutes, a long alert beep will emit. ![]() Low Battery Low Battery is indicated by a flashing LED. Lost-Alarm When the pinpointer is switched on but has been inactive for approximately 3 minutes, a long alert beep will emit. Three short beeps will emit and the pinpointer will power off. When the detected object is very close to the probe, the beep becomes a continuous tone. When a detection occurs, the vibration will intensify, and the beeps will emit increasingly closer together. When auto-calibration is complete, a short beep indicates that the pinpointer is ready to use. The unit will beep twice and the LED (3)* will illuminate. ![]() With probe at least 300mm/1' away from metal objects, press the Power button.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |